Announcement

Collapse
No announcement yet.

DFI 662-TMG/G motherboard review-The Conroe supported SIS integrated budge solution

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • DFI 662-TMG/G motherboard review-The Conroe supported SIS integrated budge solution


  • #2
    Re: DFI 662-TMG/G motherboard review-The Conroe supported SIS integrated budge solution

    The lower left hand corner:
    South bridge is SIS 966, built-in with four SATA ports
    and integrated with RAID 0, RAID 1 and JBOD functions.
    Just a pity this M/B does not support SATA II, but is still equipped with two
    IDE channels.







    The upper right hand corner
    Two single channel DRAM slots, support DDRII 533/667







    CPU surrounded area:
    3-phase PWM power design
    with good quality Solid Aluminum electrolytic capacitors.








    I/O components
    Realtek ALC655 6 channels audio chip
    SIS 196 Gigabit network controller

    Comment


    • #3

      Comment


      • #4
        Re: DFI 662-TMG/G motherboard review-The Conroe supported SIS integrated budge solution

        DFI 662-TMG/G BIOS Introduction
        Frequency/Voltage Control page







        CPU clock setting range 266~533Mhz









        DRAM frequency ratio











        CPU VID Offset setting
        0.025~0.375V

        Comment


        • #5
          Re: DFI 662-TMG/G motherboard review-The Conroe supported SIS integrated budge solution

          DDRII Voltage range
          1.8~2.5V








          Chip Set Voltage setting







          DRAM Clock/Timing Control







          Test Environment
          CPU:INTEL Core 2 Extreme X6800
          MB: DFI 662-TMG/G
          DRAM:Corsair TWIN2X2048-6400C3
          VGA:ELSA 6800Ultra
          HD:Seagate 7200.7 80GB
          POWER:AcBel 550W
          Cooler:Tower112

          Comment


          • #6
            Re: DFI 662-TMG/G motherboard review-The Conroe supported SIS integrated budge solution

            X6800 OC 300X11=>3300Mhz
            SIS chipset could also reach FSB 300 stable?








            DFI 662-TMG/G
            Strength:
            1. Under 85 U.S. dollars Conroe supported M/B
            2. One PCI-E 16X for expansion card
            3. Two IDE ATA133 channels
            4. The heat generation is very acceptable for Northbridge during normal
            system operation.
            5. The Voltage/Frequency setting is considered as feature rich for All in one
            M/B products.
            6. Front Side Bus could reach 300Mhz stable.
            7. Well performed on USB high speed data transmission.


            Weakness:
            1. does not support SATA II
            2. No DVI
            3. The temperature of Southbridge is slightly higher, suggest to add a heat
            sink for better heat absorption.
            4. The VGA performance is just enough for daily usage.
            5. No dual channel for memory.




            After the post of first review, some people think the price is slightly too high,
            perhaps it is because the price of SIS 661 M/B was just about 50~60 US
            dollars. SIS 662 is a whole new product, even though the improvement is not
            so large, it is still quite normal to have higher price in this IT industry.

            As we said previously,
            it will be a very economic PC solution to fit with Intel E4300 CPU or Pentium D
            805/PD915, plus add-on graphics card, this solution will offer outstanding
            performance.



            Obviously there are still so many improvements SIS could do to refine this
            product, and as far as we concern, focus on All-in-one market segment will
            not be a cure for its long term survival.

            Comment

            Working...
            X