If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
with bios FD8 x58 UD3R 1.6, when restarting PC, and instantly opening CPU-Z it won't show the idle speed multi x12 [speedstep enabled] but it show the low idle vcore only , it will just show full speed 21x multi for like 2 minutes and the vcore showing idle volt and CPU Usage is 0%, but CORETEMP and CPUTweaker show the correct speed after reboot fine, so maybe cpu-z bug?
I have 21x multi chosen manually in bios.
The F9m for EX58-EXTREME has the same issue with the multiplier: in full load it only engages the x21 multi for 1 second every 15sec or so, then it goes back to x20.
The latest bios that worked good with this was f9d, i think.
The F9m for EX58-EXTREME has the same issue with the multiplier: in full load it only engages the x21 multi for 1 second every 15sec or so, then it goes back to x20.
The latest bios that worked good with this was f9d, i think.
Comment