If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
BIOS F11i on first page ,for Z390 Master supose (?) to fix this.
Thanks
For me it flashes fine and I see the initial POST screen, but when using the DEL key it will give me a blank screen and will not enter the BIOS. The PC has to be reset.
Thankfully the END key works to get access to the QFlash. Also F12 works to access the boot menu. Those keys will not work, of course, if you have already used the DEL key to try and get into the BIOS, you will be stuck at a blank screen then.
After trying to enter bios and screen go's black. Try turning the monitor off and back on, I had something like this some time ago. If it is the same thing that is
After trying to enter bios and screen go's black. Try turning the monitor off and back on, I had something like this some time ago. If it is the same thing that is
Good idea.
I tried that and found that the monitor does detect a DP input and stays on rather than going into standby but still with a very black screen.
Tried it with a DP cable and a HDMI cable.
When on the POST screen or the F12 boot screen or within QFlash it is fine BUT I can't get into the BIOS settings at all. For me it is like the FH version of the Master BIOS, except that one had the black screen from the F12 boot menu.
As noted it is a black screen as the monitor detects an active input rather than a blank screen where the monitor goes into standby.
Well it was worth a shot, i was getting a black screen and no signal was being sent on my old Samsung monitor unless i powered cycled.
But that worked out to be a problem with the age of the monitor replacing fixed that.
Hey, just updated my Z390 Aorus PRO Wi-Fi with F12g from the first page and got a problem with setting tREFI values back (was in F11, solved in F12c). Rolled back to the F12c and really hope that this bug will not be in the final version of F12.
Is there a bios available for gigabyte Z390 Gaming SLI or should i maybe try the Gaming X one, i am trying to fix the ram overclocking bios, should i maybe try the bios from the site because i am on the f8 version currently?
Is there a bios available for gigabyte Z390 Gaming SLI or should i maybe try the Gaming X one, i am trying to fix the ram overclocking bios, should i maybe try the bios from the site because i am on the f8 version currently?
Hello Stasio.
f11g (as well as f11f and f11d) are using the wrong code branch for the Z390 Master. tREFI bug and the missing menus again. F11e was using the correct branch. I know everyone is busy with Z490 but if you have time, please leave a note for the bios team! Thank you.
It seems that the Bios F9f for the Z390 Aorus Xtreme suffers from the same problem as the Z390 Aorus Master with the wrong code branch.
Back in Bios Version F9c, is was possible to set tREFI to a given value. Since Bios Version F9e, if you enter a value bigger than 9998 it is set to 65535.
You can replicate this issue back to Bios Version F9e and the new version F9f.
Maybe you can forward this to the dev team. Thank you.
Comment