Good evening fellow oc'ers. I'm trying to run 333 x 10 on the 333 Mhz strap with 3.2B Multiplier. My GA-EP43-DS3LR doesn't want to boot with 3.2B, but it will post with 2.4B at this speed. My RAM I'm using is OCZ Fatal1ty PC2-8500 1066 Mhz @ 6-7-7-20 2.0V. I have manually set my timings and voltage for my RAM and when I tried 333 x 10 with the 333 Mhz strap and 3.2B multi, it won't boot. What could be causing my board from posting when using the 333 Mhz strap and 3.2B multi?
I was previously doing 266 x 12.5 on the 266 Mhz Strap with a multiplier of 4.00A. I wanted to see if trying out 333 x 10 on the 333 Mhz strap would yield more performance. I'm currently doing 333 x 10 on the 333 Mhz strap with a multi of 2.4B. My RAM is running stable at PC2-6400 800 Mhz @ 5-5-5-15 1.8V The only benchmark I have ran so far is Super Pi (probably isn't good to measure memory bandwidth), but it seems stable. I know every board varies as to what strap should be used, but does anyone have any suggestions?
I was previously doing 266 x 12.5 on the 266 Mhz Strap with a multiplier of 4.00A. I wanted to see if trying out 333 x 10 on the 333 Mhz strap would yield more performance. I'm currently doing 333 x 10 on the 333 Mhz strap with a multi of 2.4B. My RAM is running stable at PC2-6400 800 Mhz @ 5-5-5-15 1.8V The only benchmark I have ran so far is Super Pi (probably isn't good to measure memory bandwidth), but it seems stable. I know every board varies as to what strap should be used, but does anyone have any suggestions?
Comment