Hi,
My x58 extreme starting to operating bad. (can't raise bclk more than 160, altough it was on 190 since few month without problem. I't not cpu or mem problem, I lowered them of course to test what causing the problem)
So I'm going to replace my x58-extreme board to new one.
My question is there is any reason except usb3 to go for a newer ud7 board, or stick with the same board ?
If somebody was on extreme or ud5 before ud7, any info opinion would be great.
The best would be extreme v2.0 of course...
I waited for x-58 extreme rev2.0 but no info about release date, no info from Lsdmeasap too.
Thanks,
Pubem
My x58 extreme starting to operating bad. (can't raise bclk more than 160, altough it was on 190 since few month without problem. I't not cpu or mem problem, I lowered them of course to test what causing the problem)
So I'm going to replace my x58-extreme board to new one.
My question is there is any reason except usb3 to go for a newer ud7 board, or stick with the same board ?
If somebody was on extreme or ud5 before ud7, any info opinion would be great.
The best would be extreme v2.0 of course...
I waited for x-58 extreme rev2.0 but no info about release date, no info from Lsdmeasap too.
Thanks,
Pubem
Comment