Hi,
I was wondering what are the differences in the SATA ports on this board? There are (2) purple ones GSATA2 (assuming controlled by Gigabyte Controller) and (6) yellow/orange ones (assuming using an Intel controller).
The reason I ask is I just got a new Vertex Turbo SSD drive and have it connected to GSATA2_0 (purple) and have my optical drive on SATA2_0 (yellow)...is this correct? I mean the machine boots, etc but it shows it as Master on Channel 5 or something. The OCZ documentation says to install it on the lowest numbered port. Also OCZ recommends AHCI mode which I've enabled in the BIOS (entry at top) BUT there's another selection for AHCI/RAID about halfway down in that same list. But if i change that one I have issues with the drive not being seen so it's set at IDE.
At this point I only have the OS on the drive and would like to pull it and start over if I've done something that's prohibiting the maximum performance.
Do I have it backwards? Should my boot/HDD be in SATA2_0 (orange) and my optical drive be in GSATA2_0?
Thanks in advance for any help/advice...this is my first build and so far hasn't been very much fun
I was wondering what are the differences in the SATA ports on this board? There are (2) purple ones GSATA2 (assuming controlled by Gigabyte Controller) and (6) yellow/orange ones (assuming using an Intel controller).
The reason I ask is I just got a new Vertex Turbo SSD drive and have it connected to GSATA2_0 (purple) and have my optical drive on SATA2_0 (yellow)...is this correct? I mean the machine boots, etc but it shows it as Master on Channel 5 or something. The OCZ documentation says to install it on the lowest numbered port. Also OCZ recommends AHCI mode which I've enabled in the BIOS (entry at top) BUT there's another selection for AHCI/RAID about halfway down in that same list. But if i change that one I have issues with the drive not being seen so it's set at IDE.
At this point I only have the OS on the drive and would like to pull it and start over if I've done something that's prohibiting the maximum performance.
Do I have it backwards? Should my boot/HDD be in SATA2_0 (orange) and my optical drive be in GSATA2_0?
Thanks in advance for any help/advice...this is my first build and so far hasn't been very much fun
![Whatever Anim](https://www.tweaktownforum.com/core/images/smilies/Whatever_anim.gif)
Comment