I’ve been running my X58A-UD3R rev.2 machine, a daily worker, for 2 years or so.
It sleeps each night and wakes each morning with a mouse click.
Just recently, it will not respond, so I push the main power button, the red light flickers and no start.
It simply flickers on, goes off, and will not even flicker again until I flip the PSU switch off for a bit.
After repeated attempts, it eventually starts normal.
I do note some yellow and green lights in the DDR voltage bank when it is dead, these do turn off once the system finally boots.
No software errors are showing up.
Is this simply a case of bad Power Supply? It never misses a beat under use conditions.
I’m sure this is a duplicate post, but I couldn’t find a similar thread.
tia
It sleeps each night and wakes each morning with a mouse click.
Just recently, it will not respond, so I push the main power button, the red light flickers and no start.
It simply flickers on, goes off, and will not even flicker again until I flip the PSU switch off for a bit.
After repeated attempts, it eventually starts normal.
I do note some yellow and green lights in the DDR voltage bank when it is dead, these do turn off once the system finally boots.
No software errors are showing up.
Is this simply a case of bad Power Supply? It never misses a beat under use conditions.
I’m sure this is a duplicate post, but I couldn’t find a similar thread.
tia
Comment