I've Lost My Direction

[Valkyrie]

Ok so I have not done this for awhile and I figure the easiest way would be to ask Whats a safe voltage increase for CPU & MEM & AGP and what are the average increases for my GF4 any help appriciated

[Darthtanion]

Processor - 1.85v should be your maximum unless you get some high-end cooling in place (water, vapor, peltier).

Memory - Default is 2.5v so you can take it to 2.7 or 2.8 without any problems. I'd go with some sort of active cooling if you decide to go higher.

AGP - Depends on the AGP version you're using. AGP 2x uses a default 3.3v, AGP 4x uses 1.5v and AGP 8x uses 0.8v as default levels. A general rule is no more than 10% unless you aggressively cool the component. The MX440 card you have in your signature will probably be running at AGP 4x standards, so take it from there. As to the overclocking levels on that board,it has been too long since I played with one to be able to give a valid answer. The old Prolink model I tested some time ago was able to run nicely at 300/450, but depending on the memory used on yours, you may be able to get a good bit more out of it than I did.

[Valkyrie]

Thanks for the reply heres how Im going so far one teadeously slow step at a time
AMD Athlon XP 1600+/1400Mhz @ 1800+/1533Mhz (140Mhz FSB 1.750v Vcore Temps CPU 44'c-52'c Case 32'c-36'c Ambient 28'c-33'c)
Jetway V333DA A KT333 Award Bios Revision A04 (VIA 4in1 4.43)
A-Data 256MB DDR PC2100 (2.6v DIMM)
ST Labs GeForce4 MX 440 64 MB DDR @ AGP 4X 285/430 (1.6v Detonator 40.72)
I was abel to raise my 3d mark score from 5423 to 6126
oh and my AGP voltage does not go any higher than 1.6